bgm - Item number: BGM7782FRKS Availability: in stock (Please check the availability here in the Scooter Center Shop) Weight: approx. 0,09 kg Category: Frame> Shock absorbers> Shock absorbers Other customers who are interested in rear shock absorber fork (spare part) -BGM PRO SC / R12 COMPETITION, 330mm- Vespa PX, Rally - silver interested, also looked for: shock absorbers | Rear | Shock absorber | [...]

Repair and upgrade kit for the primary gear reduction of all Vespa Wideframe engines, e.g. Vespa VM, VN, VL, VB, VNA, VNB, VBA. The springs contained in the large primary gear serve as shock absorbers. They protect the gear unit from high load peaks. If they are too soft in relation to the engine torque, they are completely compressed and give the unfiltered peak pressures to the gearbox.

The centrifugal weights in the variator are wearing parts and must be changed at regular intervals depending on the load (wear check approx. Every 5000 km). Wear of the rollers is characterized by a flattening on one side, the rollers can then no longer slide properly in the runway of the variator. This results in poor acceleration and often also a lower [...]

Castle nut for: Rear wheel bearings: Vespa 125 - VNA, VNB, GT125 (up to 78300), GTR125 (up to 124013) Vespa 150 - VBA, VBB, VGLA, VGLB, GL150, Sprint (up to No. 1170239), Sprint Veloce (up to No. 169300) Front wheel bearing: Vespa 160GS, 180SS Ø outside: 49mm Ø inside (shaft seal seat): 37mm slots: 9pcs. Height: 12,5mm Suitable tool - article no. 1800018 bgm - Item number: BGM4937 [...]

Shock absorbers from the BGM PRO SC series are THE coilover kit for Vespa with TÜV! The chassis developed by BGM in Germany is available with an ABE for almost all Vespa scooters. The shock absorbers are fully adjustable and offer an incomparable driving experience that was previously unknown on a scooter. with ABE individually [...]

bgm - Item number: BGM7752B Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 2,69 kg Category: Frame> Shock absorbers> Shock absorbers Other customers who are interested in rear shock absorbers -BGM PRO SC / R1 SPORT , 360mm- Vespa Primavera 125, Vespa Primavera 150, Vespa Sprint 125, Vespa Sprint 150 - black are interested, searched [...]

Clutch lining that is the first to sit under the circlip of the basket. Therefore only has a one-sided covering. Already included in the complete covering set BGM8085SKT and BGM8085PKT. RECOMMENDATION We recommend a low-alloy gear oil of classes API GL3 / GL4, even for high-performance engines, in order to prevent the clutch from slipping even under extreme loads. This also applies to our [...]

Our BGM Pro nozzle and needle sets make the work of adjusting the carburetor much easier. The nozzle sizes extend over a wide range. This means that the right nozzle should always be with you. The practical boxes are a pleasant side effect, so the nozzles are always in the right place and the hours of rummaging through mountains of nozzles are finally over [...]

BGM gear shoulder rings are manufactured with high precision. They are hardened and ground plane-parallel to the hundredth of a millimeter. They therefore correspond exactly to the specified dimensions. The quality assurance guarantees a maximum deviation of only four hundredths of a millimeter undersize. This makes the BGM discs much more precise than Piaggio shoulder rings. WHY shoulder rings are used to compensate for the axial play between [...]

TIP: Please always assemble piston rings carefully. Piston rings made of cast material are only elastic to a limited extent and break relatively quickly. Some pistons have trapezoidally profiled piston rings (so-called keystone rings), these only fit in one installation position. If the ring does not move freely, please loosen it carefully and put it back in 'upside down'. Very helpful tools for work [...]

Complete set, which unfortunately often becomes due when thieves were at work. bgm - Item number: R246050281 Availability: In stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,75 kg Category: Frame> Body> Locks Other customers who are interested in lock set -MBK / YAMAHA- Yamaha Aerox (YQ50 / L, 2-stroke) (2003-), MBK Nitro (YQ50 / L, [...]

Front brake drum 9 "+ 10" -BGM PRO cast iron- Vespa V50 R (V5A1T to No. 752188), V50 N, V50 S, V50 L, SR50, V90 brake drum "Made in Germany" by Strohspeed for BGM PRO. Suitable for all Vespa V50 models with 4-hole rims. Made of high-quality cast iron, it offers enormous advantages over conventional brake drums made of thin [...]