Our three-pole electronic flasher relay is ideal as a replacement for a conventional flasher relay. Most manufacturers use an inexpensive mechanical relay ex works, this clocks only depending on the attached load, i.e. on the wattage of the indicator bulbs used. If this is changed significantly, for example through the use of LED technology, clocking is only possible indirectly with such a relay. One of them is the use of load resistors that are used as short-circuit wiring between the two cables of the respective indicator. The disadvantage is the great effort to lay everything neatly and neatly as well as to stow the sensitive resistor break-proof, also you are usually required to cut around the original wiring harness, which in the event of a possible retrofitting entails work again. The resistors can also get relatively hot and they unnecessarily load the on-board network, as the LED indicators offer the advantage that they need very little electricity. The solution is simple and easy, a load-independent relay is needed. This is simply connected in place of the original and the correct timing required by law is restored. Our relay has the following identification: Assignment: L = Light / Licht (ie to the indicator switch) E = Earth / ground connection to the frame B = Battery + / or switched on-board voltage ...
- bgm - item number: BGM6203
- Availability: in stock (Please check availability here in Scooter Center Shop)
- Weight: approx. 0,05 kg
- Category: Frame> electrical system> flasher relay
Other customers who are interested in flasher relay -UNIVERSAL 3-Pin LED- 12V 0,1-0,85A - (1,2-10 Watt) also looked for: Flasher relay | Flasher relay | Relay | Turn signal | Controller | Flasher unit | Flasher | Control | Flasher | Relay | Relay Clignotant | Intermettenza Frecce | Relé De Intermitente |