BGM clutch pinions are bulletproof. Developed for the enormous power and torque of today's engines, they are made from high-alloy steel (SCM415 / 15 CrMo 5) according to the highest manufacturing standards. The extremely high strength of the base material (up to 1100N / mm2, HRC 58-62) provides a reassuringly secure basis for the production of BGM pinions. The production meets the high [...]

bgm - Item number: BGM6412RB Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,14 kg Category: Frames> Cables> Cables Other customers who are looking for rear brake cables -BGM ORIGINAL Ø = 2,9, XNUMXmm with eyelet- Vespa PX - black are interested, also looked for: brake cable | Brake cable | Brake cable | Rear | [...]

Our BGM Pro nozzle and needle sets make the work of adjusting the carburetor much easier. The nozzle sizes extend over a wide range. This means that the right nozzle should always be with you. The practical boxes are a pleasant side effect, so the nozzles are always in the right place and the hours of rummaging through mountains of nozzles are finally over [...]

Brake pads BGM PRO Sintersport - massive stopping power The BGM PRO sintered brake pads are a new generation of pads. It is all-metal brake pads that are manufactured in a complex sintering process. With these pads, braking performances are achieved that meet the highest demands. QUALITY The BGM Pro brake pads are manufactured exclusively for BGM by one of the most renowned Italian brake pad manufacturers. [...]

bgm - Item number: BGM6476TX Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,07 kg Category: Workshop supplies> Trains Other customers who are interested in end cap for outer cable -BGM ORIGINAL- Ø inside = 6mm - 10pcs. interested, also searched for: end cap | Outer cable | End cap | Pull sleeve | Pull cap | Sleeve | Grommet [...]

BGM PRO wire rope hoists correspond to the factory specification and impress with their high quality and low price. All trains have vehicle-specific lengths and can therefore be installed directly without rework. Particular attention was paid to high-quality details such as double-pressed end sleeves, burr-free nipples or tinned wire ends. Installation is quick and easy. To the [...]

bgm - Item number: BGM6606GTS Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,02 kg Category: Frame> Electronics> Turn signals Other customers who are looking for cable adapter kit for turn signal conversion -BGM PRO update 2003-2013 => 2014- Vespa GTS 125-300 rear - used for indicators from 2014 onwards in vehicles before 2014 are interested, [...]

If a crankshaft with a longer stroke is used, this additional stroke has to be compensated for for two reasons. On the one hand due to the mechanical conditions to prevent the piston from hitting or the engine runs too highly compressed, on the other hand to keep the control angle of the cylinder, which determines the performance, within a reasonable range. If the stroke is extended, [...]

PRIMARY KIT BGM PRO EXTRA LONG Motors with a lot of torque and an early power peak choose the straight-toothed clutches that also require a straight-toothed primary gear (also available as a set with clutch). This enables very long reductions to be achieved. Also perfectly suitable if the overall transmission ratio is changed in very sporty engines with a modified auxiliary shaft and shorter gear steps.

Air filter fleece BGM PRO for Vespa Smallframe V50, 50N, PV, ET3 High quality filter fleece from Marchald (Italy), manufactured for BGM PRO. Suitable for all smallframe motors with sheet metal air filter box. 1: 1 replacement for the original wire mesh. Significantly better and finer filtering. Protects the engine as no fragments of the old wire mesh can be sucked in. Also ideal for performance-enhanced engines with increased [...]

High quality electric cable with robust PVC sheath. Available in many different colors, such as those used in Piaggio vehicles. Available in cable cross-sections of 0,85mm² and 2,0mm². Outside diameter 0,85mm² = Ø2,3mm outside diameter 2,0mm² = Ø3,1mm Cable type: Single core Insulation: Special PVC according to DIN ISO 6722 and LV112 Temperature range: -40 to + 120 ° C Conductor: Bare copper wire Length: 10 meters [... ]

High-quality CNC sports levers from bgm PRO for vehicles with cable brakes at the front. Suitable for Vespa Largeframe models built in 1957-1998: PX, T5, Sprint, Rally, GT, GTR, TS, VNA, VNB, VBB, VBA, GS, SS180 Smallframe built in 1963-1989: V50, 50N, V90, PV125, ET3 , PK S *, PK XL1 * Milled from solid aluminum, with an elegant, resistant, hard-anodized surface. Ergonomically clear [...]