The bgm EVOLUTION crankshafts are racing shafts of the highest quality. The completely forged shafts are finely balanced full metal shafts. Both the crank webs and the connecting rod are forged. This gives the wave an incredible resilience. In order to achieve the highest possible weight, which is extremely important for low-vibration engine operation, the shafts were [...]

bgm - Item number: BGM6413ST Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,06 kg Category: Frames> Cables> Cables Other customers who are interested in choke cables -BGM ORIGINAL- Vespa PX Lusso ( from 1984) - interested in black, also looked for: Choke cable | Cold start train | Cold start | Choke cable | [...]

bgm - Item number: SC1808 Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,00 kg Category: Other customers who are interested in Banner -BGM ORIGINAL- Banner 175x120cm also looked for:

TIP: Please always assemble piston rings carefully. Piston rings made of cast material are only elastic to a limited extent and break relatively quickly. Some pistons have trapezoidally profiled piston rings (so-called keystone rings), these only fit in one installation position. If the ring does not move freely, please loosen it carefully and put it back in 'upside down'. Very helpful tools for work [...]

bgm - Item number: BGM6478TX Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,15 kg Category: Workshop supplies> Trains Other customers who are interested in end cap for outer cable -BGM ORIGINAL- Ø inside = 8mm - 10pcs. interested, also searched for: end cap | Outer cable | End cap | Pull sleeve | Pull cap | Sleeve | Grommet [...]

bgm - Item number: SC4012 Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,02 kg Category: Frame> Rubber parts> Seals Other customers who are interested in sealing tank / fuel tap -BGM ORIGINAL 24 × 43,5x3mm- Vespa Wideframe VN, VM, ACMA- cork are interested, also looked for: Seal | Tank | Fuel tap | Seal tank / fuel tap [...]

Motor housing bolt set that contains all removable motor bolts of the motor housing. The bolts are made of high-strength steel (10.9) and are permanently protected against corrosion by a browning process. Also included are the snap rings, washers and nuts, all of which are galvanized. The set corresponds to the original dimensions used ex works and is a high-quality 1: 1 replacement for the original [...]

bgm - Item number: BGM1770BS15 Availability: in stock (Please check the availability here in the Scooter Center Shop) Weight: approx. 0,05 kg Category: Engine> Seals> Spacer Other customers who are looking for Spacer cylinder base -BGM ORIGINAL 177/187 ccm - Vespa PX125, PX150, Cosa125, Cosa150, GTR125, TS125, Sprint Veloce (VLB1T 0150001-) - 1,5mm interested, searched [...]

The BGM PRO ignition set made of high-quality components for a quick conversion of the Vespa to a maintenance-free, powerful and reliable ignition / generator unit. FEATURES Conversion from contact ignition to electronic ignition bright light already in idle voltage-stabilized 12 volt on-board network maintenance-free and reliable electronic ignition starts immediately good concentricity lighter, balanced pole wheel more power better acceleration alternator [...]

Open intake manifold for Minarellis with upright cylinder Intake manifold with a small connection, suitable for the carburettors with a small connection width (Areche 17,5 - 21 mm, Dellorto 12 - 19 mm). Decent increase in performance, as the engine can finally breathe freely. The result is better acceleration values ​​and freer turning and thus higher top speed. bgm - Article number: A201 Availability: on [...]

bgm - Item number: BGM6398UG Availability: in stock (Please check availability here in the Scooter Center Shop) Weight: approx. 0,17 kg Category: Frames> Cables> Cables Other customers who are interested in universal train -BGM ORIGINAL, Ø = 1.6 mm x 2500mm, sleeve = 2200mm, nipple Ø = 5.5mm x 7.5mm, inner sleeve PE, gray - used as a shift cable are interested, also looked for: [...]

Exhaust BGM Pro BigBox TOURING Banana for Vespa PK models. The BGM Pro complete exhaust system in the TOURING version offers the discreet look and acoustics of an original system in conjunction with a high-torque and broadband characteristic. Originally designed as a replacement for the original Piaggio exhaust systems that are no longer available, it has been developed into a full-fledged sports exhaust system. Huge [...]